Scheduling A Reboot On The Switch; Configuring Real-Time Monitoring Of The Running Status Of The System - 3Com 4200G 12-Port Configuration Manual

Before rebooting, the system checks whether there is any configuration change. If yes, it prompts
whether or not to proceed. This prevents the system from losing the configurations in case of shutting
down the system without saving the configurations
Use the following command to reboot the Ethernet switch:
To do...
Reboot the Ethernet switch

Scheduling a Reboot on the Switch

After you schedule a reboot on the switch, the switch will reboot at the specified time.
Follow these steps to schedule a reboot on the switch:
Schedule a reboot on the switch, and
set the reboot date and time
Schedule a reboot on the switch, and
set the delay time for reboot
Enter system view
Schedule a reboot on the switch, and
set the reboot period
The switch timer can be set to precision of one minute, that is, the switch will reboot within one minute
after the specified reboot date and time.

Configuring Real-time Monitoring of the Running Status of the System

This function enables you to dynamically record the system running status, such as CPU, thus
facilitating analysis and solution of the problems of the device.
Follow these steps to configure real-time monitoring of the running status of the system:
To do...
Enter system view
Enable real-time monitoring of
the running status of the
system
reboot [ unit unit-id ]
To do...
system-view
system-monitor enable
Use the command...
Use the command...
schedule reboot at hh:mm
[ mm/dd/yyyy | yyyy/mm/dd ]
schedule reboot delay { hh:mm |
mm }
system-view
schedule reboot regularity at
hh:mm period
Use the command...
4-2
Remarks
Available in user view
Remarks
Optional
Optional
—
Optional
Remarks
—
Optional
Enabled by default.