Table of Contents
Advertisement
396
C
18: M
S
F
HAPTER
ANAGING
YSTEM
ILES
# Configuration nvgen'd at 2004-5-10 19:08:38
# Image 2.1.0
# Model WX1200
# Last change occurred at 2004-5-10 16:31:14
set vlan 1 port 1
set vlan 10 name backbone tunnel-affinity 5
set vlan 10 port 7
set vlan 10 port 8
set vlan 3 name red tunnel-affinity 5
set igmp mrsol mrsi 60 vlan 1
set igmp mrsol mrsi 60 vlan 10
Saving Configuration
To save the running configuration to a configuration file, use the
Changes
following command:
save config [filename]
If you do not specify a filename of up to 128 alphanumeric characters,
the command replaces the startup configuration file that was loaded the
last time the software was rebooted. (To display the filename of that
configuration file, see "Displaying Boot Information" on page 389.)
To save the running configuration to the file loaded the last time the
software was rebooted, type the following command:
WX1200# save config
success: configuration saved.
To save the running configuration to a file named newconfig, type the
following command:
WX1200# save config newconfig
success: configuration saved to newconfig.
Specifying the
By default, the WX switch loads the configuration file named
Configuration File to
configuration from nonvolatile storage following a software reboot. To
Use After the Next
use a different configuration file in nonvolatile storage after rebooting,
Reboot
use the following command:
set boot configuration-file filename
Advertisement
Table of Contents
