Enabling And Disabling Vlt Tagging On A Port; Setting The Bridge Spanning Tree Forward Delay - 3Com SuperStack II Manual

114 C 4: W
HAPTER ORKING
Enabling and
Disabling VLT Tagging
on a Port
Setting the Bridge
Spanning Tree
Forward Delay
W C L
ITH THE OMMAND INE
Blocking - equivalent to STP blocking state
Listening - equivalent to STP listening state
Learning - equivalent to STP learning state
Forwarding - equivalent to STP forwarding state
Broken - port is broken
fwdTransitions
entered the forwarding state from the learning state.
— Displays the current path cost associated with the port.
stpCost
You can enable or disable VLT tagging on a port of the current Switch
unit using the
vltMode
To enable or disable VLT tagging on a port:
1 At the Top-level menu, enter:
bridge port vltMode
The following prompt is displayed:
Select bridge ports (1-12) [1]:
2 Enter the number of the port to have VLT tagging enabled or disabled.
The following prompt is displayed:
Enter new value (disable, enable) [disable]:
3 Enter or
enable disable
You can set the bridge forward delay spanning tree parameter of the
current Switch using the
menu.
To set the bridge spanning tree forward delay:
1 At the Top-level menu, enter:
bridge stpForwardDelay
The following prompt is displayed:
Enter new value in seconds (4-30) [15]:
2 Enter the new value for the forward delay.
I
NTERFACE
— Displays the number of times this port has
command on the Port menu.
.
stpForwardDelay
command on the Bridge