Displaying The System Status; Debugging The System - 3Com 4210 PWR Configuration Manual

484 C 42: B
HAPTER ASIC
Displaying the System
Status
Debugging the
System
Enabling/Disabling
System Debugging
S C
YSTEM ONFIGURATION AND
You can use the following display commands to check the status and
configuration information about the system. For information about protocols and
ports, and the associated display commands, refer to relevant sections.
Table 355 System information display commands
Operation
Display the current date and
time of the system
Display the version of the
system
Display the information about
users logging onto the switch
The device provides various debugging functions. For the majority of protocols and
features supported, the system provides corresponding debugging information to
help users diagnose errors.
The following two switches control the display of debugging information:
Protocol debugging switch, which controls protocol-specific debugging
■
information
Screen output switch, which controls whether to display the debugging
■
information on a certain screen.
Figure 170 illustrates the relationship between the protocol debugging switch and
the screen output switch. Assume that the device can output debugging
information to module 1, 2 and 3. Only when both are turned on can debugging
information be output on a terminal.
D
EBUGGING
Command
display clock
display version
display users [ all ]
Description
You can execute the display
commands in any view