About Luns In Ivr Zoning; Configuring Luns In Ivr Zoning; About Qos In Ivr Zones; Configuring Qos For Ivr Zones - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

IVR Zones and IVR Zone Sets
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Click Copy to copy the topology.
Step 6

About LUNs in IVR Zoning

LUN zoning can be used between members of active IVR zones. You can configure the service by
creating and activating LUN zones between the desired IVR zone members in all relevant edge VSANs
using the zoning interface or you can use LUN zoning directly supported by IVR. For more details on
the advantages of LUN zoning, see the

Configuring LUNs in IVR Zoning

You can configure LUN zoning in an IVR zone set setup.
To configure LUNs in IVR zoning, refer to the Cisco MDS 9000 Family CLI Configuration Guide.

About QoS in IVR Zones

You can configure a QoS attribute for an IVR zone. The default QoS attribute setting is low.

Configuring QoS for IVR Zones

To configure QoS for an IVR zone using Fabric Manager, follow these steps:
Choose Zone > Edit Local Full Zone Database.
Step 1
You see the Edit IVR Local Full Zone Database dialog box for the VSAN you selected.
Select Zones or a zone set.
Step 2
Check the QoS check box and set the QoS priority.
Step 3
Click Activate to make the changes.
Step 4
If other QoS attributes are configured, the highest setting takes priority.
Note

Renaming IVR Zones and IVR Zone Sets

You can rename IVR zones and IVR zone sets.
To rename an IVR zone or IVR zone set, using Fabric Manager, follow the steps below:
Choose Zone > Edit Local Full Zone Database.
Step 1
You see the Edit IVR Local Full Zone Database dialog box for the VSAN you selected.
Cisco MDS 9000 Family Fabric Manager Configuration Guide
29-30
"About LUN Zoning" section on page
Chapter 29 Configuring Inter-VSAN Routing
30-40.
OL-17256-03, Cisco MDS NX-OS Release 4.x