Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual page 441

Chapter 20 Configuring Interfaces
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Expand Switches > Interfaces and then select Management.
Step 1
Figure 20-14
Step 2 Click Create Row.
You see the Create Interface dialog box (see
Figure 20-15
Step 3 Select the switch and VSAN ID for which you want to configure a VSAN interface.
Note
Step 4 Set IPAddress/Mask to the IP address and subnet mask for the new VSAN interface.
Step 5 Click Create to create the VSAN interface or click Close to close the dialog box without creating the
VSAN interface.
Default Settings
Table 20-7
OL-17256-03, Cisco MDS NX-OS Release 4.x
General Management Tab
Create Interface Dialog Box
You can only create a VSAN interface for an existing VSAN. If the VSAN does not exist, you
cannot create a VSAN interface for it.
lists the default settings for interface parameters.
Figure 20-15).
Cisco MDS 9000 Family Fabric Manager Configuration Guide
Default Settings
20-31