Configuring The Default Zone Policy; About Broadcast Zoning - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Advanced Zone Attributes
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 30-38
Step 4 Check the Permit QoS Traffic with Priority check box and set the Qos Priority drop-down menu to
low, medium, or high.
Click OK to save these changes.
Step 5

Configuring the Default Zone Policy

To permit or deny traffic in the default zone using Fabric Manager, follow these steps:
Choose Zone > Edit Local Full Zone Database.
Step 1
You see the Select VSAN dialog box.
Select a VSAN and click OK.
Step 2
You see the Edit Local Full Zone Database dialog box for the selected VSAN.
Choose Edit > Edit Default Zone Attributes to configure the default zone QoS priority attributes.
Step 3
You see the Modify Default Zone Properties dialog box shown in
Figure 30-39
Set the Policy drop-down menu to permit to permit traffic in the default zone, or set it to deny to block
Step 4
traffic in the default zone.
Click OK to save these changes.
Step 5

About Broadcast Zoning

Broadcast zoning is not supported on the Cisco Fabric Switch for HP c-Class BladeSystem and the Cisco
Note
Fabric Switch for IBM BladeCenter.
Cisco MDS 9000 Family Fabric Manager Configuration Guide
30-38
QoS Priority Attributes
Modify Default Zone Properties Dialog Box
Chapter 30 Configuring and Managing Zones
Figure 30-39.
OL-17256-03, Cisco MDS NX-OS Release 4.x