Enabling Or Disabling Fcdomains; Setting Fabric Names; About Incoming Rcfs - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Fibre Channel Domains
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Enabling or Disabling fcdomains

To disable fcdomains in a single VSAN or a range of VSANs using Fabric Manager, follow these steps:
Expand Fabricxx > VSANxx and then select Domain Manager in the Logical Domains pane for the
Step 1
fabric and VSAN that you want to disable fcdomain for.
You see the domain's running configuration in the Information pane.
Click the Configuration tab and uncheck the Enable check box (see
Step 2
fabric that you want to disable fcdomain on.
Figure 25-5
Click the Apply Changes icon to save these changes.
Step 3

Setting Fabric Names

To set the fabric name value for a disabled fcdomain using Fabric Manager, follow these steps:
Expand Fabricxx > VSANxx and then select Domain Manager in the Logical Domains pane for the
Step 1
fabric and VSAN that you want to set the fabric name for.
You see the running configuration of the domain in the Information pane.
Click the Configuration tab and set the fabric name for each switch in the fabric.
Step 2
Click the Apply Changes icon to save these changes.
Step 3

About Incoming RCFs

You can choose to reject RCF request frames on a per-interface, per-VSAN basis. By default, the RCF
reject option is disabled (that is, RCF request frames are not automatically rejected).
The RCF reject option takes immediate effect to runtime through a disruptive restart (see the
Domain Restart" section on page
Cisco MDS 9000 Family Fabric Manager Configuration Guide
25-6
Configuring Domains
25-3).
Chapter 25 Configuring Domain Parameters
Figure 25-5) for each switch in the
OL-17256-03, Cisco MDS NX-OS Release 4.x
"About