Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual page 667

Chapter 30 Configuring and Managing Zones
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
You see the Create Zone dialog box shown in
Figure 30-10
Enter a zone name.
Step 4
Check one of the following check boxes:
Step 5
Read Only—The zone permits read and denies write.
a.
Permit QoS traffic with Priority—You set the priority from the drop-down menu.
b.
Restrict Broadcast Frames to Zone Members
c.
Click OK to create the zone.
Step 6
If you want to move this zone into an existing zone set, skip to
Click Zoneset in the left pane and click the Insert icon to create a zone set.
Step 7
You see the Zoneset Name dialog box shown in
Figure 30-11
Enter a zone set name and click OK.
Step 8
Note
Select the zone set where you want to add a zone and click the Insert icon or you can drag and drop
Step 9
Zone3 over Zoneset1.
You see the Select Zone dialog box shown in
OL-17256-03, Cisco MDS NX-OS Release 4.x
Create Zone Dialog Box
Zoneset Name Dialog Box
One of these symbols ($, -, ^, _) or all alphanumeric characters are supported. In interop mode
2 and 3, this symbol (_) or all alphanumeric characters are supported.
Figure 30-10.
Step 8.
Figure 30-11.
Figure 30-12.
Cisco MDS 9000 Family Fabric Manager Configuration Guide
Zone Configuration
30-13