About Persistent Fc Id Selective Purging; Purging Persistent Fc Ids - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Chapter 25 Configuring Domain Parameters
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 25-13
Step 8 Click Apply Changes to save this new FC ID.
Compare the FC ID values to verify the FC ID of the HBA.
Step 9
Note
E pand Switches > Interfaces and then select FC Physical from the Physical Attributes pane. Set the
Step 10
X
Status Admin drop-down menu to up for the interface that the HBA is connected to.
This enables the HBA interface in the MDS switch.
Step 11

About Persistent FC ID Selective Purging

Persistent FC IDs can be purged selectively. Static entries and FC IDs currently in use cannot be deleted.
Table 25-1
Table 25-1
Persistent FC ID state
Static
Static
Dynamic
Dynamic

Purging Persistent FC IDs

To purge persistent FC IDs using Fabric Manager, follow these steps:
Expand Fabricxx > All VSANs > Domain Manager in the Logical Domains pane for the fabric that you
Step 1
want to purge the Persistent FC IDs for. You see the running configuration of the domain in the
Information pane.
Click the Persistent Setup tab.
Step 2
You see the persistent FC ID setup in the Information pane shown in
OL-17256-03, Cisco MDS NX-OS Release 4.x
Setting the FC ID in Fabric Manager
Both FC IDs now have different area assignments.
identifies the FC ID entries that are deleted or retained when persistent FC IDs are purged.
Purged FC IDs
Persistent Usage State
In use
Not in use
In use
Not in use
Cisco MDS 9000 Family Fabric Manager Configuration Guide
FC IDs
Action
Not deleted
Not deleted
Not deleted
Deleted
Figure 25-14.
25-21