Disabling Bandwidth Fairness - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Chapter 22 Configuring Generation 2 and Generation 3 Switching Modules
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 22-16
Click the enable radio button to enable bandwidth fairness.
Step 2
Click Apply to save the changes.
Step 3

Disabling Bandwidth Fairness

If you disable bandwidth fairness, up to a 20 percent increase in internal bandwidth allocation is possible
Note
for each port group; however, bandwidth fairness is not guaranteed when there is a mix of shared and
full-rate ports in the same port group.
To disable bandwidth fairness on multiple 48-port or 24-port 4-Gbps, or 8-Gbps Fibre Channnel
switching modules using Device Manager, follow these steps:
Choose Physical > Modules.
Step 1
You see the Module dialog box as shown in
Select disable from the BandwidthFairnessConfig drop-down list for each module for which you want
Step 2
to disable bandwidth fairness.
Click Apply to save the changes.
Step 3
To disable bandwidth fairness on a single 48-port or 24-port 4-Gbps, or 8-Gbps Fibre Channel switching
module using Device Manager, follow these steps:
Right-click a module and select Configure.
Step 1
You see the Module dialog box as shown in
Click the disable radio button to disable bandwidth fairness.
Step 2
OL-17256-03, Cisco MDS NX-OS Release 4.x
Module Dialog Box
Cisco MDS 9000 Family Fabric Manager Configuration Guide
Configuring Module Interface Shared Resources
Figure 22-15.
Figure 22-16.
22-39