Configuring Zone-Based Traffic Priority; Configuring Default Zone Qos Priority Attributes - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Chapter 30 Configuring and Managing Zones
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Configuring Zone-Based Traffic Priority

To configure the zone priority using Fabric Manager, follow these steps:
Expand a VSAN and then select a zone set in the Logical Domains pane.
Step 1
Click the Policies tab in the Information pane.
Step 2
You see the Zone policy information in the Information pane (see
Figure 30-37
Use the check boxes and drop-down menus to configure QoS on the default zone.
Step 3
Click Apply Changes to save the changes.
Step 4

Configuring Default Zone QoS Priority Attributes

QoS priority attribute configuration changes take effect when you activate the zone set of the associated
zone.
If a member is part of two zones with two different QoS priority attributes, the higher QoS value is
Note
implemented. This situation does not arise in the VSAN-based QoS as the first matching entry is
implemented.
To configure the QoS priority attributes for a default zone using Fabric Manager, follow these steps:
Choose Zone > Edit Local Full Zone Database.
Step 1
You see the Select VSAN dialog box.
Select a VSAN and click OK.
Step 2
You see the Edit Local Full Zone Database dialog box for the selected VSAN.
Step 3 Choose Edit > Edit Default Zone Attributes to configure the default zone QoS priority attributes (see
Figure
OL-17256-03, Cisco MDS NX-OS Release 4.x
Zone Policies Tab in the Information Pane
30-38).
Figure
Cisco MDS 9000 Family Fabric Manager Configuration Guide
Advanced Zone Attributes
30-37).
30-37