Cfs Example Using Fabric Manager - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

CFS Example Using Fabric Manager

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 13-14
Figure 13-14
Step 3 Click Yes to confirm deletion of the region.
CFS Example Using Fabric Manager
This procedure is an example of what you see when you use Fabric Manager to configure a feature that
uses CFS.
Select the CFS-capable feature you want to configure. For example, expand a VSAN, and then select
Step 1
Port Security in the Logical Domains pane.
You see the port security configuration for that VSAN in the Information pane.
Click the CFS tab.
Step 2
You see the CFS configuration and status for each switch (see
Figure 13-15
From the Feature Admin drop-down list, select enable for each switch.
Step 3
Step 4 Repeat step 3 for all switches in the fabric.
Note
Step 5 Check the Master check box for the switch to act as the merge master for this feature.
From the Config Action drop-down list, select commit Changes for each switch that you enabled for
Step 6
CFS.
Step 7 Click the Servers tab in the Information pane.
Cisco MDS 9000 Family Fabric Manager Configuration Guide
13-20
shows a confirmation dialog box.
Deleting CFS Regions
CFS Configuration
A warning is displayed if you do not enable CFS for all switches in the fabric for this feature.
Chapter 13 Using the CFS Infrastructure
Figure 13-15).
OL-17256-03, Cisco MDS NX-OS Release 4.x