Launching Flexattach In Fabric Manager - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Chapter 14 Configuring FlexAttach Virtual pWWN
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 14-1
You see the FlexAttach window.
Figure 14-2
Check the VirtualPwwnAuto check box to enable automatic generation of virtual WWNs on all the
Step 2
fabric port interfaces.
Note •
•

Launching FlexAttach in Fabric Manager

To launch FlexAttach in Fabric Manager, follow these steps:
In the Logical Domains pane, select a switch.
Step 1
In the Physical Attributes pane, expand Switches > NPIV.
Step 2
Select NPIV > N_Port Virtualizer (NPV) > FlexAttach.
Step 3
The FlexAttach configuration pane appears to the right.
OL-17256-03, Cisco MDS NX-OS Release 4.x
FlexAttach in Device Manager
FlexAttach Window in Device Manager
When the interface-list value is not included in the command, virtual pWWN is enabled globally.
All the interfaces mentioned in the interface-list value must be in a shut state.
(Figure 14-2).
(Figure
Cisco MDS 9000 Family Fabric Manager Configuration Guide
Configuring FlexAttach Virtual pWWN
14-3).
14-3