Configuring Iscsi; About Iscsi - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Configuring iSCSI

Cisco MDS 9000 Family IP storage (IPS) services extend the reach of Fibre Channel SANs by using
open-standard, IP-based technology. The switch allows IP hosts to access Fibre Channel storage using
the iSCSI protocol.
The iSCSI feature is specific to the IPS module and is available in Cisco MDS 9200 Switches or Cisco
Note
MDS 9500 Directors.
The Cisco MDS 9216i switch and the 14/2 Multiprotocol Services (MPS-14/2) module also allow you
to use Fibre Channel, FCIP, and iSCSI features. The MPS-14/2 module is available for use in any switch
in the Cisco MDS 9200 Series or Cisco MDS 9500 Series.
For information on configuring Gigabit Ethernet interfaces, see
Note
Interfaces for IPv4" section on page
This chapter includes the following sections:
•
•
•
•
•
•
•
•

About iSCSI

The iSCSI feature is not supported on the Cisco Fabric Switch for HP c-Class Bladesystem and Cisco
Note
Fabric Switch for IBM BladeCenter.
OL-17256-03, Cisco MDS NX-OS Release 4.x
About iSCSI, page 50-1
Configuring iSCSI, page 50-4
Configuring iSLB, page 50-35
iSCSI High Availability, page 50-50
iSCSI Authentication Setup Guidelines and Scenarios, page 50-56
iSNS, page 50-67
iSNS Cloud Discovery, page 50-73
Default Settings, page 50-75
C H A P T E R
52-4.
Cisco MDS 9000 Family Fabric Manager Configuration Guide
50
"Configuring Gigabit Ethernet
50-1