Creating Performance Collections - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Admin
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Click the Admin tab and then click Configure.
Step 1
Click Local Roles in the left navigation pane.
Step 2
Click the radio button next to the role you want to remove and click Remove.
Step 3

Creating Performance Collections

If you are managing your fabrics with Performance Manager, you need to set up an initial set of flows
and collections on the fabric. You can use Fabric Manager Web Client to add and remove performance
collections. The fabric has to be licensed and in the Managed Continuously state before a collection for
the fabric can be created.
You cannot manage performance collections for multiple devices through a single port interface. Since
Note
only one set of statistics exists per interface, Fabric Manager Web Client can manage performance
collections for only one visible FL or iSCSI device through an interface.
To add a collection using Fabric Manager Web Client, follow these steps:
Click the Admin tab, and then click Configure.
Step 1
Click Collections in the left navigation pane.
Step 2
You see the Collections page as shown in
Figure 7-51
Click Add.
Step 3
You see the Create Collection dialog box shown in
Cisco MDS 9000 Family Fabric Manager Configuration Guide
7-56
Figure
Collections Page
Chapter 7
7-51.
Figure 7-52.
OL-17256-03, Cisco MDS NX-OS Release 4.x
Fabric Manager Web Client