About Interop Mode; About Ficon Vsans; Default Settings - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Default Settings

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Click Apply Changes to save these changes, or click Undo Changes to discard any unsaved changes.
Step 3

About Interop Mode

Interoperability enables the products of multiple vendors to come into contact with each other. Fibre
Channel standards guide vendors towards common external Fibre Channel interfaces. See the
Interoperability" section on page

About FICON VSANs

You can enable FICON in up to eight VSANs. See the
page
Default Settings
Table 26-2
Table 26-2
Parameters
Default VSAN
State
Name
Load-balancing attribute
Cisco MDS 9000 Family Fabric Manager Configuration Guide
26-12
36-7.
lists the default settings for all configured VSANs.
Default VSAN Parameters
37-8.
"FICON VSAN Prerequisites" section on
Default
VSAN 1.
Active state.
Concatenation of VSAN and a four-digit string representing the
VSAN ID. For example, VSAN 3 is VSAN0003.
OX ID (src-dst-ox-id).
Chapter 26 Configuring and Managing VSANs
OL-17256-03, Cisco MDS NX-OS Release 4.x
"Switch