Replacing With A Server On A Different Switch - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Using the Server Admin FlexAttach Wizards
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
The New Port window is displayed.
In the New Port selection window, select the port on which the spare server is connected.
Step 7
Click Next.
Step 8
The Server WWN window is displayed.
Figure 14-21
In the Server WWN window displayed, enter the existing FlexAttach server virtual port WWN to be
Step 9
replaced, and the new server physical port WWN.
Check the Allow wizard to change from "pWWN to vPWWN" mapping to "interface to vPWWN"
Step 10
mapping check box to remove the pWWN to vPWWN entry from the CFS Region mapping table, and
configure the mapping only at the interface.
Click Finish to complete the FlexAttach configuration for the spare server.
Step 11

Replacing with a Server on a Different Switch

To replace a server with a spare server on a different switch, follow these steps:
In the Fabric Manger window, select Tools > FlexAttach > Replace Server.
Step 1
The Replace Server wizard is displayed.
Cisco MDS 9000 Family Fabric Manager Configuration Guide
14-22
(Figure
(Figure
Server WWN Entries
(Figure
Chapter 14
14-16)
14-21)
14-18)
OL-17256-03, Cisco MDS NX-OS Release 4.x
Configuring FlexAttach Virtual pWWN