Port Security Manual Configuration - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Chapter 46 Configuring Port Security
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Table 46-2
listed refer to the conditions from
Table 46-2
Device Connection Request
P1, N2, F1
P2, N2, F1
P3, N2, F1
P1, N3, F1
P1, N1, F3
P1, N4, F5
P5, N1, F5
P3, N3, F4
S1, F10
S2, F11
P4, N4, F5 (auto-learning on)
P4, N4, F5(auto-learning off)
S3, F5 (auto-learning on)
S3, F5 (auto-learning off)
P1, N1, F6 (auto-learning on)
P5, N5, F1 (auto-learning on)
S3, F4 (auto-learning on)
S1, F3 (auto-learning on)
P5, N3, F3
P7, N3, F9

Port Security Manual Configuration

To configure port security on any switch in the Cisco MDS 9000 Family, follow these steps:
Step 1 Identify the WWN of the ports that need to be secured.
Secure the fWWN to an authorized nWWN or pWWN.
Step 2
Activate the port security database.
Step 3
Verify your configuration.
Step 4
This section includes the following topics:
•
•
OL-17256-03, Cisco MDS NX-OS Release 4.x
summarizes the port security authorization results for this active database. The conditions
Authorization Results for Scenario
About WWN Identification, page 46-16
Adding Authorized Port Pairs, page 46-16
Table 46-1.
Authorization Condition
Permitted 1
Permitted 1
Denied 2
Permitted 6
Permitted 5
Denied 2
Denied 2
Permitted 1
Permitted 1
Denied 7
Permitted 3
Denied 4
Permitted 3
Denied 4
Denied 2
Denied 7
Denied 7
Permitted 5
Permitted 6
Permitted 6
Cisco MDS 9000 Family Fabric Manager Configuration Guide
Port Security Manual Configuration
Reason
No conflict.
No conflict.
F1 is bound to P1/P2.
Wildcard match for N3.
Wildcard match for F3.
P1 is bound to F1.
N1 is only allowed on F2.
No conflict.
No conflict.
P10 is bound to F11.
No conflict.
No match.
No conflict.
No match.
P1 is bound to F1.
Only P1 and P2 bound to F1.
P3 paired with F4.
No conflict.
Wildcard ( * ) match for F3
and N3.
Wildcard ( * ) match for N3.
46-15