Chapter 12 Initial Configuration; Verifying The Module Status - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Verifying the Module Status

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Double-click the Logical Name of the switch you want to change in the Information pane.
Step 3
You see the name highlighted with a blinking cursor next to it.
Figure 12-1
Type the new name of the switch (see
Step 4
Click the Apply Changes icon.
Step 5
Right-click the Fabric pane map and choose Refresh to see your changes.
Step 6
.
Verifying the Module Status
Before you begin configuring the switch, you need to ensure that the modules in the chassis are
functioning as designed.
To verify the status of a module at any time, follow these steps:
Expand SAN in the Logical Domains pane, then select a fabric or a VSAN from the Logical Domains
Step 1
pane.
Step 2 Expand Switches and choose Hardware in the Physical Attributes pane.
You see the contents of the Inventory tab in the Information pane shown in
Figure 12-2
Click the Card Module Status tab.
Step 3
You see the status in the Oper Status column of each module in each switch of the SAN, fabric, or VSAN
you selected.
Cisco MDS 9000 Family Fabric Manager Configuration Guide
12-2
Changing the Logical Name of a Switch
Figure
Inventory of a Selected Module
12-1).
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 12 Initial Configuration
Figure 12-2.