Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual page 889

Chapter 42 Configuring IPv4 and IPv6 Access Control Lists
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
You see the Create IP ACL Profiles dialog box shown in
Figure 42-3
Enter an IP-ACL profile name.
Step 3
Click Create and then click Close.
Step 4
This creates a new IP-ACL profile.
Click the IP-ACL you created and click Rules.
Step 5
After you create an IPv4-ACL or an IPv6-ACL, you can add subsequent IP filters at the end of the
IPv4-ACL or the IPv6-ACL if you are using Device Manager. Fabric Manager allows you to reorder
existing rules for a profile. You cannot insert filters in the middle of an IPv4-ACL or an IPv6-ACL. Each
configured entry is automatically added to the end of a IPv4-ACL or an IPv6-ACL.
You see the IP ACL dialog box shown in
Figure 42-4
Click Create to create an IP filter.
Step 6
You see the Create IP Filter dialog box shown in
OL-17256-03, Cisco MDS NX-OS Release 4.x
Create IP ACL Profiles Dialog Box
Figure
IP ACL Profile Dialog Box
Cisco MDS 9000 Family Fabric Manager Configuration Guide
Creating IPv4-ACLs or IPv6-ACLs with the IP-ACL Wizard
Figure 42-3.
42-4.
Figure 42-5.
42-7