Pre-Configuring Flexattach For All The Ports - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Using the Server Admin FlexAttach Wizards
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Pre-Configuring FlexAttach for All the Ports

Using the Pre-Configure Server Basic configuration wizard, you can set the following port
configurations for all the ports in one or more switches in common:
To pre-configure a common setting for all the ports in one or more switches, follow these steps:
In the Fabric Manger window, select Tools > FlexAttach > Pre-configure Server.
Step 1
The Pre-Configure Wizard is displayed.
Figure 14-9
In the Pre-Configure Server window, click the Basic radio button to configure a common setting to all
Step 2
the ports on one or more switches.
The Basic Configuration window is displayed.
Cisco MDS 9000 Family Fabric Manager Configuration Guide
14-10
Enable or disable FlexAttach Auto on all ports
–
Set the default VSAN ID for all the ports
–
Set the interface status for all the ports.
–
Pre-Configure Server Wizard
Chapter 14
(Figure 14-9)
(Figure 14-10)
Configuring FlexAttach Virtual pWWN
OL-17256-03, Cisco MDS NX-OS Release 4.x