Configuring Rate Mode - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Chapter 22 Configuring Generation 2 and Generation 3 Switching Modules
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 22-11
The auto parameter enables autosensing on the interface. The autoMax2G parameter enables autosensing
on the interface with a maximum speed of 2 Gbps.
Note
Step 5 Click the Apply Changes icon.
.

Configuring Rate Mode

To configure the rate mode (dedicated or shared) on an interface on a 4-Gbps or 8-Gbps Fibre Channel
switching module using Fabric Manager, follow these steps:
Select a switch from the Fabric pane, or select a group of switches (SAN, fabric, VSAN) from the
Step 1
Logical Domains pane.
Expand Switches > Interfaces and then select FC Physical from the Physical Attributes pane.
Step 2
You see the FC Physical > General tab in the Interfaces pane.
Scroll until you see the row containing the switch and port you want to configure.
Step 3
Select dedicated or shared from the Rate Mode column (see
Step 4
Figure 22-12
OL-17256-03, Cisco MDS NX-OS Release 4.x
Speed Admin Column in Port Configuration
If you change the port bandwidth reservation parameters on a 48-port or 24-port 4-Gbps, or any
8-Gbps Fibre Channel switching module, the change affects only the changed port. No other
ports in the port group are affected.
Rate Mode Port Configuration
Configuring Module Interface Shared Resources
Figure
Cisco MDS 9000 Family Fabric Manager Configuration Guide
22-12).
22-33