Default Settings - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Chapter 32 Configuring Fibre Channel Routing Services and Protocols
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Expand a fabric and select All VSANS.
Step 1
You see the VSAN configuration in the Information pane.
Select the Attributes tab.
Step 2
You see the general VSAN attributes in the Information pane shown in
Figure 32-16
Double-click the Network Latency field and change the value.
Step 3
Click Apply Changes to save these changes, or click Undo Changes to discard any unsaved changes.
Step 4

Default Settings

Table 32-4
Table 32-4
Parameters
FSPF
SPF computation
SPF hold time
Backbone region
Acknowledgment interval (RxmtInterval)
Refresh time (LSRefreshTime)
Maximum age (MaxAge)
Hello interval
Dead interval
Distribution tree information
OL-17256-03, Cisco MDS NX-OS Release 4.x
General VSAN Attributes
lists the default settings for FSPF features.
Default FSPF Settings
Default
Enabled on all E ports and TE ports.
Dynamic.
0.
0.
5 seconds.
30 minutes.
60 minutes.
20 seconds.
80 seconds.
Derived from the principal switch (root node).
Cisco MDS 9000 Family Fabric Manager Configuration Guide
Default Settings
Figure 32-16.
32-19