Presenting Fibre Channel Targets As Iscsi Targets - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Chapter 50 Configuring iSCSI
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Select the VSAN and targets to associate with this iSCSI initiator and click Next.
Step 4
Note
You see the iSCSI Wizard Select Zone dialog box shown in
Figure 50-8
Set the zone name for this new iSCSI zone and check the ReadOnly check box if needed.
Step 5
Click Finish to create this iSCSI initiator.
Step 6
If created, the target VSAN is added to the iSCSI host VSAN list.
Note iSCSI wizard automatically turns on the Dynamic FC target import.

Presenting Fibre Channel Targets as iSCSI Targets

The IPS module or MPS-14/2 module presents physical Fibre Channel targets as iSCSI virtual targets,
allowing them to be accessed by iSCSI hosts. It does this in one of two ways:
•
OL-17256-03, Cisco MDS NX-OS Release 4.x
The iSCSI wizard turns on the Dynamic Import FC Targets feature.
iSCSI Wizard Select Zone Dialog Box
Dynamic mapping—Automatically maps all the Fibre Channel target devices/ports as iSCSI
devices. Use this mapping to create automatic iSCSI target names.
Figure 50-8.
Cisco MDS 9000 Family Fabric Manager Configuration Guide
Configuring iSCSI
50-7