Converting Zone Members To Pwwn-Based Members - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Zone Sets
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 30-26
Note
Click the browse button and select a port name or check the LUN check box and click the browse button
Step 4
to configure LUNs.
Click Add to add the member to the alias.
Step 5

Converting Zone Members to pWWN-based Members

You can convert zone and alias members from switch port or FC ID based membership to pWWN-based
membership. You can use this feature to convert to pWWN so that your zone configuration does not
change if a card or switch is changed in your fabric.
To convert switch port and FC ID members to pWWN members using Fabric Manager, follow these
steps:
Choose Zone > Edit Local Full Zone Database.
Step 1
You see the Select VSAN dialog box.
Select a VSAN and click OK.
Step 2
You see the Edit Local Full Zone Database dialog box for the selected VSAN.
Click the zone you want to convert.
Step 3
Choose Tools > Convert Switch Port/FCID members to By pWWN.
Step 4
You see the conversion dialog box, listing all members that will be converted.
Step 5 Verify the changes and click Continue Conversion.
Cisco MDS 9000 Family Fabric Manager Configuration Guide
30-24
Add Member to Alias Dialog Box
The Device Alias radio button is visible only if device alias is in enhanced mode. For more
information, see "Creating a Device Alias" section on page
Chapter 30 Configuring and Managing Zones
31-6.
OL-17256-03, Cisco MDS NX-OS Release 4.x