Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual page 1127

Chapter 50 Configuring iSCSI
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 50-42
o.01.255891611111
.01.25589167F74C
To configure scenario 1 (see
Configure null authentication for all iSCSI hosts in Cisco MDS switches.
Step 1
In Fabric Manager, choose End Devices > iSCSI in the Physical Attributes pane.
a.
Select none from the AuthMethod drop-down menu in the Information pane.
b.
Click the Apply Changes icon.
c.
Configure iSCSI to dynamically import all Fibre Channel targets into the iSCSI SAN using
Step 2
auto-generated iSCSI target names.
In Device Manager, click IP > iSCSI.
a.
Click the Targets tab.
b.
Check the Dynamically Import FC Targets check box.
c.
Click Apply.
d.
Configure the Gigabit Ethernet interface in slot 7 port 1 with an IPv4 address and enable the interface.
Step 3
In Fabric Manager, choose Switches > Interfaces > Gigabit Ethernet in the Physical Attributes
a.
pane.
Select the IP Address tab in the Information pane and click Create Row.
b.
Set the IP address and subnet mask for the Gigabit Ethernet interface in slot 7 port 1.
c.
Click Create.
d.
OL-17256-03, Cisco MDS NX-OS Release 4.x
The iSCSI initiator host 1 with IPv4 address 10.11.1.10 and name
–
iqn.1987-05.com.cisco:01.255891611111 connects to IPS port 7/1 is identified using IPv4
address (host 1 = 10.11.1.10).
The iSCSI initiator host 2 with IPv4 address 10.15.1.10 and node name
–
iqn.1987-05.com.cisco:01.25589167f74c connects to IPS port 7/5.
iSCSI Scenario 1
7/1
Host 1
10.11.1.10
iSCSI
10.15.1.10
iSCSI
Host 2
7/5
Figure
iSCSI Authentication Setup Guidelines and Scenarios
iSCSI-zone-1
Switch 1
iSCSI-zone-2
50-42), follow these steps:
Cisco MDS 9000 Family Fabric Manager Configuration Guide
Interface fc 2/1
21:00:00:20:37:6f:fd:97
Interface fc 2/5
21:00:00:20:37:6f:fe:54
Interface fc 2/9
21:00:00:20:37:a6:a6:5d
50-59