Clearing Ike Tunnels Or Domains; Refreshing Sas - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Optional IKE Parameter Configuration
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Click Create to create this initiator version or click Close to discard any unsaved changes.
Step 6

Clearing IKE Tunnels or Domains

If an IKE tunnel ID is not specified for the IKE configuration, you can clear all existing IKE domain
connections.
To clear all the IKE Tunnels or Domains using Fabric Manager, follow these steps:
Expand Switches > Security and then select IKE in the Physical Attributes pane.
Step 1
You see the IKE configuration in the Information pane (see
Figure 44-15
Click the Tunnels tab in the Information pane.
Step 2
You see the IKE tunnels.
Click the Action column and select Clear to clear the tunnel.
Step 3

Refreshing SAs

To refresh the SAs after changing the IKEv2 configuration using Fabric Manager, follow these steps:
Expand Switches > Security and then select IKE in the Physical Attributes pane.
Step 1
You see the IKE configuration shown in
Cisco MDS 9000 Family Fabric Manager Configuration Guide
44-20
IKE Configuration
Figure
Chapter 44 Configuring IPsec Network Security
Figure 44-15).
44-16.
OL-17256-03, Cisco MDS NX-OS Release 4.x