Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual page 510

Configuring Module Interface Shared Resources
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Caution
Select disabled from the RateModeOversubscriptionLimit drop-down list for each module for which
Step 2
you want to disable restrictions on oversubscription ratios.
Click Apply to save the changes.
Step 3
To disable restrictions on oversubscription ratios on a single 48-port or 24-port 4-Gbps, or any 8-Gbps
Fibre Channel switching module using Device Manager, follow these steps:
Right-click a module and select Configure.
Step 1
You see the Module dialog box as shown in
Figure 22-14
Click the disabled radio button to disable restrictions on oversubscription ratios.
Step 2
Click Apply to save the changes.
Step 3
Cisco MDS 9000 Family Fabric Manager Configuration Guide
22-36
This feature is only supported on 48-port and 24-port 4-Gbps, and 8-Gbps Fibre Channel
switching modules.
Module Dialog Box
Chapter 22 Configuring Generation 2 and Generation 3 Switching Modules
Figure 22-14.
OL-17256-03, Cisco MDS NX-OS Release 4.x