Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual page 1077

Chapter 50 Configuring iSCSI
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 50-9
IP host A
iSCSI iSCSI
iqn.host A
Note Each iSCSI initiator may not have access to all targets depending on the configured access control
mechanisms (see the
To enable dynamic mapping of Fibre Channel targets into iSCSI using Device Manager, follow these
steps:
Choose IP > iSCSI.
Step 1
You see the iSCSI configuration (see
Figure 50-10
Click the Targets tab to display a list of existing iSCSI targets (see
Step 2
Figure 50-11
Check the Dynamically Import FC Targets check box.
Step 3
Click Apply to save this change.
Step 4
OL-17256-03, Cisco MDS NX-OS Release 4.x
Dynamic Target Mapping
MDS-mgntIP
iSCSI
IP Network
1/1
iqn.1987-05.com.cisco:05.<mgnt-IPaddr>.01-01.3100112233445566
"iSCSI Access Control" section on page
Figure
iSCSI Configuration in Device Manager
iSCSI Targets Tab
Cisco MDS 9000 Family Fabric Manager Configuration Guide
pwwn 31.00.11.22.33.44.55.66
Virtual iSCSI Target
LUN0
LUN1
LUN2
50-24).
50-10).
Figure
Configuring iSCSI
LUN0
LUN1
LUN2
50-11).
50-9