Manually Enabling Flexattach Virtual Pwwn - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Configuring FlexAttach Virtual pWWN
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 14-3 FlexAttach Menu

Manually Enabling FlexAttach Virtual pWWN

You can manually assign a WWN to the interface, without generating it through the switch. Several
checks are done by the NPV core to ensure the uniqueness of virtual pWWNs in the switch. When
duplicate virtual pWWNs are configured, the subsequent logins are rejected by the NPV core switch.
Note •
•
.
To enable virtual pWWN on each interface manually, follow these steps:
Click the Virtual PWWN tab.
Step 1
A list of interfaces is displayed.
Cisco MDS 9000 Family Fabric Manager Configuration Guide
14-4
Some ports may be in automode, some in manual mode, and the virtual pWWNs need not be
assigned.
The port must be in a shut state when a virtual pWWN is enabled.
(Figure 14-4).
Chapter 14 Configuring FlexAttach Virtual pWWN
OL-17256-03, Cisco MDS NX-OS Release 4.x