Manually Enabling Ficon On A Vsan; Deleting Ficon Vsans - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Configuring FICON
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 36-9
Enter the VSAN membership information.
Step 12
Click the VSAN you want to become a FICON VSAN and select Add from the FICON drop-down menu.
Step 13
Click Apply to save these changes.
Step 14

Manually Enabling FICON on a VSAN

This section describes the procedure to manually enable FICON on a VSAN. If you have already enabled
Note
FICON on the required VSAN using the automated setup (recommended), skip to the
Saving the Running Configuration" section on page
To manually enable FICON on a VSAN using Fabric Manager, follow these steps:
Choose VSAN > FICON.
Step 1
You see the FICON VSAN configuration information in the Information pane.
Select the switch in the VSAN on which you want to enable FICON.
Step 2
Click enable from the Command drop-down menu.
Step 3
Click the Apply Changes icon to save these changes.
Step 4

Deleting FICON VSANs

To delete a FICON VSAN using Fabric Manager, follow these steps:
Select All VSANS.
Step 1
You see the VSAN table in the Information pane (see
Cisco MDS 9000 Family Fabric Manager Configuration Guide
36-18
VSAN Dialog Box in Device Manager
Chapter 36
36-23.
Figure 36-10).
OL-17256-03, Cisco MDS NX-OS Release 4.x
Configuring FICON
"Automatically