Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual page 335

Chapter 14 Configuring FlexAttach Virtual pWWN
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 14-12
In the Interface tab, click to select a switch from the list of switches displayed in the left pane.
Step 3
The switch configuration details are displayed in the right pane with tabs and columns.
Configure the following settings, for each interface:
Step 4
In the Status column corresponding to the interface, double-click and then select up or down from
•
the drop-down list.
In the VSAN column corresponding to the interface, double-click and then select the VSAN ID from
•
the drop-down list of existing VSAN IDs.
In the Auto column corresponding to the interface, double-click and then select Auto to
•
automatically enable FlexAttach or select Manual to manually enable FlexAttach later.
Note
OL-17256-03, Cisco MDS NX-OS Release 4.x
Pre-Configure Server - Advanced Configuration
– In the Interface vPWWN cell, enter the vPWWN if Manual was selected in the Auto FlexAttach
configuration cell.
You can click Set All Auto to change all the interfaces with manual FlexAttach
configuration to Auto on the selected switch. However, if a valid vPWWN value is already
configured, then changing it to Auto does not change the configuration. Before you change
from Manual to Auto, update the Interface vPWWN column with the
00:00:00:00:00:00:00:00 value.
Using the Server Admin FlexAttach Wizards
Cisco MDS 9000 Family Fabric Manager Configuration Guide
14-13