Suspended And Isolated States; Adding An Interface To A Portchannel - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Fabric manager configuration guide, release 4.x
Hide thumbs Also See for AP775A - Nexus Converged Network Switch 5010:
Table of Contents

Advertisement

Interfaces in a PortChannel
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
The check ensures that the following parameters and settings match at both ends of a PortChannel:
A port addition procedure fails if the capability and administrative parameters in the remote switch are
incompatible with the capability and administrative parameters in the local switch. If the compatibility
check is successful, the interfaces are operational and the corresponding compatibility parameter
settings apply to these interfaces.

Suspended and Isolated States

If the operational parameters are incompatible, the compatibility check fails and the interface is placed
in a suspended or isolated state based on the configured mode:
See the

Adding an Interface to a PortChannel

By default, the CLI adds a interface normally to a PortChannel, while the Fabric Manager adds the
Note
interface by force, unless specified explicitly.
To add an interface or range of interfaces to a PortChannel using Fabric Manager, follow these steps:
Expand ISLs and then select Port Channels in the Physical Attributes pane.
Step 1
You see the PortChannels configured in the Information pane (see
Cisco MDS 9000 Family Fabric Manager Configuration Guide
23-18
Capability parameters (type of interface, Gigabit Ethernet at both ends, or Fibre Channel at both
ends).
Administrative compatibility parameters (speed, mode, rate mode, port VSAN, allowed VSAN list,
and port security).
Ports in shared rate mode can also form a PortChannel or a trunking PortChannel.
Note
Operational parameters (remote switch WWN and trunking mode).
An interface enters the suspended state if the interface is configured in the ON mode.
An interface enters the isolated state if the interface is configured in the ACTIVE mode.
"Reason Codes" section on page
20-8.
Figure
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 23
Configuring PortChannels
23-14).

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents