Identifying The Beacon Leds; About Speed Leds - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Chapter 20 Configuring Interfaces
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Expand Switches > Interfaces and then select FC Physical.
Step 1
You see the interface configuration in the Information pane.
Click the Other tab and set the RxDataFieldSize field (see
Step 2
Figure 20-9
(Optional) Set other configuration parameters using the other tabs.
Step 3
Click Apply Changes.
Step 4

Identifying the Beacon LEDs

Figure 20-10
Figure 20-10
1
2
1. See the
2. See the
3. Refer to the Cisco MDS 9000 Family hardware installation guide for your platform.

About Speed LEDs

Each port has one link LED on the left and one speed LED on the right.
OL-17256-03, Cisco MDS NX-OS Release 4.x
Changing Rx Data Size
displays the status, link, and speed LEDs in a 16-port switching module.
Cisco MDS 9000 Family Switch Interface Modes
1 3
1
Status LED
1/2-Gbps Fibre Channel port group
"Identifying Module LEDs" section on page
"About Speed LEDs" section on page
Figure
2
1
3
Link LEDs and speed LEDs
3
4
Asset tag
19-9.
20-19.
Cisco MDS 9000 Family Fabric Manager Configuration Guide
Fibre Channel Interfaces
20-9).
4
2
20-19