Tuning The Fcip Link; Using The San Extension Tuner Wizard - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Using the SAN Extension Tuner Wizard

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Tuning the FCIP Link

To tune the required FCIP link, follow these steps:
Configure the nWWN for the virtual N ports on the switch.
Step 1
Enable iSCSI on the interfaces on which you want to create the N ports.
Step 2
Configure the virtual N ports on either side of the FCIP link.
Step 3
Ensure that the virtual N ports are not visible to real initiators in the SAN. You can use zoning (see
Step 4
Chapter 30, "Configuring and Managing
Managing
the virtual N-ports to communicate with each other.
Start the SCSI read and write I/Os.
Step 5
Add more N ports (as required) to other Gigabit Ethernet ports in the switch to obtain maximum
Step 6
throughput. One scenario that may require additional N ports is if you use FCIP PortChannels.
Using the SAN Extension Tuner Wizard
Use the SAN Extension Tuner wizard to perform the these tasks:
•
•
•
•
•
•
To tune the required FCIP link using the SAN Extension Tuner Wizard in Fabric Manager, follow these
steps:
Right-click a valid FCIP link in the Fabric pane, and then select SAN Extension Tuner from the
Step 1
drop-down list. You can also highlight the link and choose Tools > Other > SAN Extension Tuner.
You see the Select Ethernet Port Pair dialog box (see
Cisco MDS 9000 Family Fabric Manager Configuration Guide
49-4
VSANs") to segregate the real initiators. Ensure that the zoning configuration is setup to allow
Configuring nWWN ports
Enabling iSCSI
Configuring Virtual N ports
Assigning SCSI read and write CLI commands
Assigning SCSI tape read and write CLI commands
Configuring a data pattern for SCSI commands
Chapter 49
Zones") or VSANs (see Chapter 26, "Configuring and
Figure 49-4).
OL-17256-03, Cisco MDS NX-OS Release 4.x
Configuring the SAN Extension Tuner