Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual page 903

Chapter 43 Configuring Certificate Authorities and Digital Certificates
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 43-1
Click Create Row.
Step 3
You see the Create RSA Key-Pair dialog box shown in
Figure 43-2
Select the switches for which you want to create the RSA key-pair.
Step 4
Assign a name to the RSA key-pair.
Step 5
Select the Size or modulus values. Valid modulus values are 512, 768, 1024, 1536, and 2048.
Step 6
Note
Note
Check the Exportable check box if you want the key to be exportable.
Step 7
Caution
Note
OL-17256-03, Cisco MDS NX-OS Release 4.x
PKI RSA Key-Pair Information
Create RSA Key-Pair Dialog Box
The security policy (or requirement) at the local site (MDS switch) and at the CA (where
enrollment is planned) are considered in deciding the appropriate key modulus.
The maximum number of key-pairs you can configure on a switch is 16.
The exportability of a key-pair cannot be changed after key-pair generation.
Only exportable key-pairs can be exported in PKCS#12 format.
Configuring CAs and Digital Certificates
Figure 43-2.
Cisco MDS 9000 Family Fabric Manager Configuration Guide
43-7