Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual page 88

Fabric manager configuration guide, release 4.x
Hide thumbs Also See for AP775A - Nexus Converged Network Switch 5010:
Table of Contents

Advertisement

Initial Setup Routine
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Enter noshut (shut is the default) to configure the default switch port interface to the shut state.
Step 17
Configure default switchport interface state (shut/noshut) [shut]: noshut
Enter on (on is the default) to configure the switch port trunk mode.
Step 18
Configure default switchport trunk mode (on/off/auto) [on]: on
Enter no (no is the default) to configure switchport port mode F.
Step 19
Configure default switchport port mode F (yes/no) [n] : no
Enter permit (deny is the default) to deny a default zone policy configuration.
Step 20
Configure default zone policy (permit/deny) [deny]: permit
Permits traffic flow to all members of the default zone.
Enter yes (no is the default) to disable a full zone set distribution (see the
Step 21
on page
Enable full zoneset distribution (yes/no) [n]: yes
You see the new configuration. Review and edit the configuration that you have just entered.
Enter no (no is the default) if you are satisfied with the configuration.
Step 22
The following configuration will be applied:
username admin password admin_pass role network-admin
username user_name password user_pass role network-admin
snmp-server community snmp_community ro
switchname switch
interface mgmt0
ip address ip_address subnet_mask
no shutdown
ip routing
ip route dest_prefix dest_mask dest_address
ip default-network dest_prefix
ip default-gateway default_gateway
ip name-server name_server
ip domain-name domain_name
telnet server enable
ssh key dsa 768 force
ssh server enable
ntp server ipaddr ntp_server
system default switchport shutdown
system default switchport trunk mode on
system default port-channel auto-create
zone default-zone permit vsan 1-4093
zoneset distribute full vsan 1-4093
Would you like to edit the configuration? (yes/no) [n]: no
Step 23
Enter yes (yes is default) to use and save this configuration:
Use this configuration and save it? (yes/no) [y]: yes
Cisco MDS 9000 Family Fabric Manager Configuration Guide
2-8
30-26). Disables the switch-wide default for the full zone set distribution feature.
Chapter 2
Installing Cisco MDS NX-OS and Fabric Manager
"Zone Set Distribution" section
OL-17256-03, Cisco MDS NX-OS Release 4.x

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents