Fabric Manager Advanced Mode; Launching Fabric Manager Client In Cisco San-Os Release 3.2(1) And Later - Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual

Launching Fabric Manager Client in Cisco SAN-OS Release 3.2(1) and Later

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Fabric Manager Advanced Mode

Advanced mode is enabled by default and provides the full suite of Fabric Manager features, including
security, IVR, iSCSI, and FICON. To simplify the user interface, from the list box in the upper right
corner of the Fabric Manager Client, select Simple. In simple mode, you can access basic MDS 9000
features such as VSANs, zoning, and configuring interfaces. Advanced mode option is not available for
server admin role.
Launching Fabric Manager Client in Cisco SAN-OS Release
3.2(1) and Later
As of Cisco SAN-OS 3.x and NX-OS Release 4.x, the Fabric Manager Client login procedure has
Note
changed. If you are running a version of Cisco SAN-OS that is earlier than Cisco SAN-OS 3.2(1), follow
the login instructions in the
section on page A-1
section on page
Note Network administrators must initially launch Fabric Manager Client using Fabric Manager Web Server,
as described in the following procedure. Once an administrator has installed the Fabric Manager Client
icon on your desktop, you can double-click the icon to launch the Fabric Manager Client.
To launch Fabric Manager Client, follow these steps:
Open your browser and enter the IP address where you installed Fabric Manager Server, or enter
Step 1
localhost if you installed Fabric Manager Server on your local workstation.
You see the Fabric Manager Web Server Login dialog box shown in
Cisco MDS 9000 Family Fabric Manager Configuration Guide
5-2
"Setting the Seed Switch in Cisco SAN-OS Releases 3.1(1) to 3.2(1)"
or the "Setting the Seed Switch in Releases Prior to Cisco SAN-OS Release 3.1(1)"
A-3.
Chapter 5 Fabric Manager Client
Figure 5-1.
OL-17256-03, Cisco MDS NX-OS Release 4.x