Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual page 137

Chapter 4 Authentication in Fabric Manager
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Launch Fabric Manager Web Server.
Step 1
See the
Click the Admin tab > Configure to update the authentication used by Fabric Manager Web Server.
Step 2
Click AAA.
Step 3
Set the authenticationmode attribute to radius.
Step 4
Set the RADIUS server name, shared secret, authentication method, and ports used for up to three
Step 5
RADIUS servers.
Click Modify to save this information.
Step 6
To configure Fabric Manager Web Server to use TACACS+ authentication, follow these steps:
Launch Fabric Manager Web Server.
Step 1
See the
Click Admin > Configure to update the authentication used by Fabric Manager Web Server.
Step 2
Click AAA.
Step 3
Set the authenticationmode attribute to tacacs.
Step 4
Set the TACACS+ server name, shared secret, authentication method, and port used for up to three
Step 5
TACACS+ servers.
Click Modify to save this information.
Step 6
Fabric Manager does not support SecureID because it is not compatible with SNMP authentication.
Note
Fabric Manager uses the same login credentials for all the switches in a fabric. Since SecureID cannot
be used more than once for authentication, Fabric Manager will not be able to establish a connection to
the second switch using a SecureID.
OL-17256-03, Cisco MDS NX-OS Release 4.x
"Launching Fabric Manager Web Client" section on page
"Launching Fabric Manager Web Client" section on page
Fabric Manager Web Server Authentication
7-7.
7-7.
Cisco MDS 9000 Family Fabric Manager Configuration Guide
4-5