Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual page 90

Initial Setup Routine
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Configure the read-only or read-write SNMP community string.
Step 5
Enter no (no is the default) to avoid configuring the read-only SNMP community string.
a.
Configure read-only SNMP community string (yes/no) [n]: no
Enter a name for the switch.
Step 6
Note
Enter the switch name: switch_name
Step 7 Enter no (yes is the default) at the configuration prompt to configure out-of-band management.
Continue with Out-of-band (mgmt0) management configuration? [yes/no]: no
Step 8 Enter yes (yes is the default) to configure the default gateway.
Configure the default-gateway: (yes/no) [y]: yes
Enter the default gateway IP address.
a.
IP address of the default gateway: default_gateway
Enter yes (no is the default) to configure advanced IP options such as in-band management, static routes,
Step 9
default network, DNS, and domain name.
Configure Advanced IP options (yes/no)? [n]: yes
Enter yes (no is the default) at the in-band management configuration prompt.
a.
Continue with in-band (VSAN1) management configuration? (yes/no) [no]: yes
Enter the VSAN 1 IP address.
VSAN1 IP address: ip_address
Enter the subnet mask.
VSAN1 IP net mask: subnet_mask
Enter no (yes is the default) to enable IP routing capabilities.
b.
Enable ip routing capabilities? (yes/no) [y]: no
Enter no (yes is the default) to configure a static route.
c.
Configure static route: (yes/no) [y]: no
Enter no (yes is the default) to configure the default network.
d.
Configure the default-network: (yes/no) [y]: no
Enter no (yes is the default) to configure the DNS IP address.
e.
Configure the DNS IP address? (yes/no) [y]: no
f. Enter no (no is the default) to skip the default domain name configuration.
Configure the default domain name? (yes/no) [n]: no
Step 10 Enter no (yes is the default) to disable Telnet service.
Enable the telnet service? (yes/no) [y]: no
Step 11 Enter yes (no is the default) to enable the SSH service.
Cisco MDS 9000 Family Fabric Manager Configuration Guide
2-10
The switch name is limited to 32 alphanumeric characters. The default is switch.
Chapter 2 Installing Cisco MDS NX-OS and Fabric Manager
OL-17256-03, Cisco MDS NX-OS Release 4.x