Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual page 86

Initial Setup Routine
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Enter the SNMPv3 password (minimum of eight characters). The default is admin123.
b.
SNMPv3 user authentication password: admin_pass
Enter yes (no is the default) to configure the read-only or read-write SNMP community string.
Step 7
Configure read-write SNMP community string (yes/no) [n]: yes
Enter the SNMP community string.
a.
SNMP community string: snmp_community
Enter a name for the switch.
Step 8
Note
Enter the switch name: switch_name
Enter yes (yes is the default) to configure out-of-band management.
Step 9
Continue with Out-of-band (mgmt0) management configuration? [yes/no]: yes
Enter the mgmt0 IP address.
a.
Mgmt0 IPv4 address: ip_address
Enter the mgmt0 subnet mask.
b.
Mgmt0 IPv4 netmask: subnet_mask
Step 10 Enter yes (yes is the default) to configure the default gateway (recommended).
Configure the default-gateway: (yes/no) [y]: yes
a. Enter the default gateway IP address.
IPv4 address of the default gateway: default_gateway
Step 11 Enter yes (no is the default) to configure advanced IP options such as in-band management, static routes,
default network, DNS, and domain name.
Configure Advanced IP options (yes/no)? [n]: yes
a. Enter no (no is the default) at the in-band management configuration prompt.
Continue with in-band (VSAN1) management configuration? (yes/no) [no]: no
Enter yes (no is the default) to enable IP routing capabilities.
b.
Enable the ip routing? (yes/no) [n]: yes
Enter yes (no is the default) to configure a static route (recommended).
c.
Configure static route: (yes/no) [n]: yes
Enter the destination prefix.
Destination prefix: dest_prefix
Type the destination prefix mask.
Destination prefix mask: dest_mask
Type the next hop IP address.
Next hop ip address: next_hop_address
Cisco MDS 9000 Family Fabric Manager Configuration Guide
2-6
The switch name is limited to 32 alphanumeric characters. The default is switch.
Chapter 2 Installing Cisco MDS NX-OS and Fabric Manager
OL-17256-03, Cisco MDS NX-OS Release 4.x