Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual page 91

Chapter 2 Installing Cisco MDS NX-OS and Fabric Manager
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Enabled SSH service? (yes/no) [n]: yes
Enter the SSH key type (see the
Step 12
would like to generate.
Type the SSH key you would like to generate (dsa/rsa/rsa1)? rsa
Step 13 Enter the number of key bits within the specified range.
Enter the number of key bits? (768 to 1024): 1024
Enter no (no is the default) to configure the NTP server.
Step 14
Configure NTP server? (yes/no) [n]: no
Enter shut (shut is the default) to configure the default switch port interface to the shut state.
Step 15
Configure default switchport interface state (shut/noshut) [shut]: shut
Note
Enter auto (off is the default) to configure the switch port trunk mode.
Step 16
Configure default switchport trunk mode (on/off/auto) [off]: auto
Enter deny (deny is the default) to deny a default zone policy configuration.
Step 17
Configure default zone policy (permit/deny) [deny]: deny
Denies traffic flow to all members of the default zone.
Enter no (no is the default) to disable a full zone set distribution (see the
Step 18
on page
Enable full zoneset distribution (yes/no) [n]: no
Disables the switch-wide default for the full zone set distribution feature.
You see the new configuration. Review and edit the configuration that you have just entered.
Enter no (no is the default) if you are satisfied with the configuration.
Step 19
The following configuration will be applied:
username admin password admin_pass role network-admin
snmp-server community snmp_community rw
switchname switch
interface vsan1
ip address ip_address subnet_mask
no shutdown
ip default-gateway default_gateway
no telnet server enable
ssh key rsa 1024 force
ssh server enable
no system default switchport shutdown
system default switchport trunk mode auto
no zone default-zone permit vsan 1-4093
no zoneset distribute full vsan 1-4093
Would you like to edit the configuration? (yes/no) [n]: no
Step 20 Enter yes (yes is default) to use and save this configuration.
Use this configuration and save it? (yes/no) [y]: yes
OL-17256-03, Cisco MDS NX-OS Release 4.x
"Generating the SSH Server Key Pair" section on page
The management Ethernet interface is not shut down at this point—only the Fibre Channel,
iSCSI, FCIP, and Gigabit Ethernet interfaces are shut down.
30-26).
Cisco MDS 9000 Family Fabric Manager Configuration Guide
Initial Setup Routine
39-17) that you
"Zone Set Distribution" section
2-11