Cisco AP775A - Nexus Converged Network Switch 5010 Configuration Manual page 87

Chapter 2 Installing Cisco MDS NX-OS and Fabric Manager
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Note
Enter yes (no is the default) to configure the default network (recommended).
d.
Configure the default network: (yes/no) [n]: yes
Enter the default network IP address.
Note
Default network IP address [dest_prefix]: dest_prefix
Enter yes (no is the default) to configure the DNS IP address.
e.
Configure the DNS IPv4 address? (yes/no) [n]: yes
Enter the DNS IP address.
DNS IPv4 address: name_server
Enter yes (default is no) to configure the default domain name.
f.
Configure the default domain name? (yes/no) [n]: yes
Enter the default domain name.
Default domain name: domain_name
Enter yes (no is the default) to enable Telnet service.
Step 12
Enable the telnet server? (yes/no) [n]: yes
Step 13 Enter yes (no is the default) to enable the SSH service.
Enabled SSH server? (yes/no) [n]: yes
Step 14 Enter the SSH key type (see the
would like to generate.
Type the SSH key you would like to generate (dsa/rsa)? dsa
Step 15 Enter the number of key bits within the specified range.
Enter the number of key bits? (768 to 2048): 768
Step 16 Enter yes (no is the default) to configure the NTP server.
Configure NTP server? (yes/no) [n]: yes
Configure clock? (yes/no) [n] :yes
Configure clock? (yes/no) [n] :yes
Configure timezone? (yes/no) [n] :yes
Configure summertime? (yes/no) [n] :yes
Configure the ntp server?
Enter the NTP server IP address.
a.
NTP server IP address: ntp_server_IP_address
OL-17256-03, Cisco MDS NX-OS Release 4.x
Be sure to configure the IP route, the default network IP address, and the default gateway IP
address to enable SNMP access. If IP routing is enabled, the switch uses the IP route and the
default network IP address. If IP routing is disabled, the switch uses the default gateway IP
address.
The default network IP address is the destination prefix provided in
"Generating the SSH Server Key Pair" section on page
(yes/no) [n] : yes
Cisco MDS 9000 Family Fabric Manager Configuration Guide
Initial Setup Routine
Step 11c .
39-17) that you
2-7