Manage Polymorphic Objects; Create A Polymorphic Object; Add A Polymorphic Object To A Pre/Post Rule - Juniper NETWORK AND SECURITY MANAGER 2010.2 - ADMINISTRATION GUIDE REV1 Administration Manual

Network and Security Manager Administration Guide

Manage Polymorphic Objects

520
Global MIP/DIP/VIP objects in current NSM are intrinsically polymorphic. For all other
categories of shared objects at Central Manager level, only concrete shared objects are
supported.
You can create polymorphic objects at the Central Manager level or the regional server
level. When polymorphic objects are created in the Central Manager they are pushed to
one or more regional servers where they are available to be populated with real values.
The workflow for using polymorphic objects is:
"Create a Polymorphic Object" on page 520
"Add a Polymorphic Object to a Pre/Post Rule" on page 520
"Map a Polymorphic Object to a Real Value" on page 521

Create a Polymorphic Object

This procedure assumes that a Central Manager administrator is logged onto a Central
Manager client.
To create a polymorphic object:
In the main navigation tree, select Object Manager.
1.
Select one of the following objects that can be polymorphic objects:
2.
Address
Service
Zone
Global NAT
Routing Instance
Click the Add icon in the toolbar and select Polymorphic Address to open the Add
3.
Polymorphic Address dialog box.
Enter the following information for the new polymorphic address, then click OK:
4.
Name
Color (optional)
IP version- IPv4 or IPv6
Comment (optional)
NSM adds the polymorphic address object to the address tree.

Add a Polymorphic Object to a Pre/Post Rule

This procedure assumes that a Central Manager administrator is logged onto a Central
Manager client.
Copyright © 2010, Juniper Networks, Inc.