Link Aggregation Configuration Examples; Layer 2 Static Aggregation Configuration Example - 3Com 4510G Configuration Manual

To do...
Display detailed information of
aggregation groups
Clear the LACP statistics of
ports
Clear the statistics of the
specified aggregate interfaces

Link Aggregation Configuration Examples

Layer 2 Static Aggregation Configuration Example

Network requirements
As shown in Figure
GigabitEthernet1/0/1 to GigabitEthernet1/0/3.
Aggregate the ports on each device to form a static link aggregation group, thus balancing outgoing
traffic across the member ports. In addition, perform load sharing based on source and destination
MAC addresses.
Figure 2-1 Network diagram for Layer 2 static aggregation
Configuration procedure
1) Configure Device A
# Configure the device to perform load sharing based on source and destination MAC addresses for
link aggregation groups.
<DeviceA> system-view
[DeviceA] link-aggregation load-sharing mode source-mac destination-mac
# Create Layer 2 aggregate interface Bridge-aggregation 1.
[DeviceA] interface bridge-aggregation 1
[DeviceA-Bridge-Aggregation1] quit
# Assign Layer 2 Ethernet interfaces GigabitEthernet1/0/1 through GigabitEthernet1/0/3 to aggregation
group 1.
[DeviceA] interface GigabitEthernet 1/0/1
[DeviceA-GigabitEthernet1/0/1] port link-aggregation group 1
Use the command...
display link-aggregation verbose
[ bridge-aggregation
[ interface-number ] ]
reset lacp statistics [ interface
interface-type interface-number [ to
interface-type interface-number ] ]
reset counters interface
[ bridge-aggregation
[ interface-number ] ]
2-1, Device A and Device B are connected through their respective Ethernet ports
2-11
Remarks
Available in any view
Available in user view
Available in user view