Tray 1 Miss Feed Jam/ Option Regi On Jam - Xerox Phaser 7100 Service Manual

Error Troubleshooting

Tray 1 Miss Feed Jam/ Option Regi On Jam

After a paper was fed from Tray 1, it did not reach the Registration Sensor.
Applicable Fault Code
• 071-101: Tray 1 Miss Feed Jam
Initial Actions
• Check the condition of the paper in tray.
• Check that the media is supported from tray.
• Check that the Paper Guides are set correctly.
• Check appropriate tray jam clearance door.
• If the problem persists, perform the following procedure.
Troubleshooting Reference
Applicable Parts
• Turn Roller Assembly, PL 2.2.1
• Feed Roller Clutch, PL 2.2.8
• Tray 1 Feed Roller Kit, PL 2.2.99
• Registration Sensor, PL 5.1.3
• Bypass Tray Turn Roller, PL 5.1.8
• Turn Roller Clutch, PL 5.1.9
• Paper Handling Motor (P/H Drive Assembly), PL 11.1.19
• MCU PWB, PL 12.1.15
• Paper Jam Sensor, PL 15.2.3
• Feeder PWB, PL 15.2.33
Troubleshooting Procedure
Step Actions and Questions
1. Check the installation of Tray 1.
Is Tray 1 installed properly?
2. Check the paper transport path.
Is there any debris found on the paper transport
path?
3. Check the installation of the Feed Rollers
2.15 Feed Roller/ Retard Roller Assembly
page 4-54).
Are the Feed Rollers installed properly?
2-246 Phaser 7100 Service Manual
Wiring and Plug/Jack Map References
Yes
Go to step 2.
Remove the debris
from the paper
transport path.
(REP Go to step 4.
on
No
Reinstall Tray 1.
Go to step 3.
Reinstall the Feed
Rollers.
Xerox Internal Use Only