Tray (1/ 2/ 3/ 4) Out Of Place - Xerox Phaser 7100 Service Manual

Error Troubleshooting

Tray (1/ 2/ 3/ 4) Out of Place

The system detected that Tray 1/ 2/ 3/ 4 was not installed.
Applicable Fault Codes
• 024-946: Tray 1 Out Of Place
• 024-947: Tray 2 Out Of Place
• 024-948: Tray 3 Out Of Place
• 024-949: Tray 4 Out Of Place
Initial Actions
• Inspect the tray to ensure that it is free of obstructions, is loaded with supported paper, and the
Guides are adjusted correctly.
• If the problem persists, perform the following procedure.
Troubleshooting Reference
Applicable Parts
• Tray 1 Paper Size Switch, PL 2.1.6
• Tray Assembly 250, PL 2.1.11
• Tray Assembly 550, PL 15.1.1
• Tray 2/3/4 Paper Size Switch, PL 15.1.5
Troubleshooting Procedure
Step Actions and Questions
1. Reseat the Tray.
If the Tray is seated properly, check the Paper Size Switch in
If it works, replace the Tray.
If it doesn't work, replace the Paper Size Switch.
• Tray 1 Paper Size Switch
• Tray 2/3/4 Paper Size Switch
2-198 Phaser 7100 Service Manual
(REP 2.6 Size Switch Holder Assembly
(REP 15.3 Size Switch Holder Assembly
Wiring and Plug/Jack Map References
DC330 Component Control
on page 4-43)
on page 4-263)
on page 2-26.
Xerox Internal Use Only