Tray 1 Error: Paper Empty - Xerox Phaser 7100 Service Manual

Tray 1 Error: Paper Empty

The system detected that Tray 1 has no paper.
Applicable Fault Code
• 024-950: Tray 1 Empty
Initial Actions
• Inspect the tray to ensure that it is free of obstructions and is loaded with supported paper.
• If the problem persists, perform the following procedure.
Troubleshooting Reference
Applicable Parts
• No Paper Sensor 250, PL 2.2.2
• Feeder Harness Assembly, PL 2.2.3
• MCU PWB, PL 12.1.5
• Main Harness Assembly, PL 12.3.1
Troubleshooting Procedure
Step Actions and Questions
1. Check the paper in the Tray.
Is the paper in the Tray loaded correctly?
2. Check the No Paper Sensor 250 operation.
Perform DC330 Component Control
page 2-26 [071-101] to check the operation of
the No Paper Sensor 250.
Is the Sensor working properly?
3. Check the connection between the No Paper
Sensor 250 and MCU PWB.
Are the connectors P/J4652A, P/J4651A, and
P/J465A connected securely?
4. Check the conductivity between the No Paper
Sensor 250 and Relay Connector.
Is the connection between P/J4652A <=>
P/J4651A conducting properly?
5. Check the conductivity between the Relay
Connector and MCU PWB.
Is the connection between P/J4651A <=>
P/J465A conducting properly?
Xerox Internal Use Only
Wiring and Plug/Jack Map References
• Paper Transport
Go to step 2.
Replace the MCU PWB
(REP 12.4 MCU PWB
on
on page 4-206).
Go to step 4.
Go to step 5.
Go to step 6.
Error Troubleshooting
on page 7-51
Yes
Load the paper.
Go to step 3.
Connect the
connectors P/J4652A,
P/J4651A, and
P/J465A.
Replace the Feeder
Harness Assembly.
Replace the Main
Harness Assembly.
Phaser 7100 Service Manual 2-199
No