Rep 11.6 Developer Drive Assembly - Xerox Phaser 7100 Service Manual

REP 11.6 Developer Drive Assembly

PL 11.1.18
CAUTION: Do not expose the Imaging Unit to light for more than 5 minutes. Cover the Imaging
Unit to avoid damage. Do not touch the surface of the Imaging Unit.
Note: The following procedure applies for all 4 Developer Drive Assemblies.
1. Remove the Imaging Unit (Y/ M/ C/ K)
2. Remove the Toner Cartridge (Y/ M/ C/ K)
page 4-136).
3. Remove Tray 1.
4. Remove the I/P PWB Cover Assembly
page 4-19).
5. Remove the Rear Cover
6. Remove the Right Side Cover
7. Remove the Left Side Cover
8. Remove the Toner Cartridge Cover Assembly
page 4-24).
9. Remove the Toner Cartridge Hinge Cover
10. Remove the Right Feeder Cover
11. Remove the Cam Cover
12. Remove the IBT Retract Cam Assembly
13. Remove the Right Imaging Unit Guide Assembly
page 4-123).
14. Remove the Left Imaging Unit Guide Assembly
page 4-129).
15. Remove the Developer Housing Assembly (Y/ M/ C/ K)
M/ C/ K) on page 4-137)
16. Remove the MCU Plate
Xerox Internal Use Only
(REP 6.0 Imaging Unit (Y/ M/ C/ K)
(REP 8.0 Toner Cartridge Assembly (Y/ M/ C/ K)
(REP 1.5 Image Processor (I/P) PWB Cover Assembly
(REP 1.6 Rear Cover on page 4-20).
(REP 1.11 Right Side Cover
(REP 1.10 Left Side Cover
(REP 1.9 Toner Cartridge Cover Assembly
(REP 1.7 Toner Cartridge Hinge Cover
(REP 2.3 Right Feeder Cover
(REP 9.7 Cam Cover on page 4-170).
(REP 9.6 IBT Retract Cam Assembly
(REP 8.7 MCU Plate on page 4-154).
on page 4-27).
on page 4-25).
on page 4-40).
(REP 6.1 Right Imaging Unit Guide Assembly
(REP 6.5 Left Imaging Unit Guide Assembly
(REP 8.1 Developer Housing Assembly (Y/
Phaser 7100 Service Manual 4-195
Service Parts Disassembly
on page 4-121).
on
on
on
on page 4-21).
on page 4-168).
on
on